Peerless PSMU-PRS Manuel télécharger pdf (Page 7)

7 of 11

ISSUED 08-09-06 SHEET #: 055-9470-5 11-21-11

Thread two 3/8-16 hex thin nylon-insert locknuts (not included) on two 3/8-16 threaded rods (not included) to the

desired height of projector mount assembly. Attach projector mount assembly (A) to two 3/8-16 threaded rods using

two 3/8-16 hex thin nylon-insert locknuts as shown in ﬁ gure 4.1 or ﬁ gure 4.2.

Skip to step 6.

Installation to Extension Column

Screw projector mount assembly (A) onto extension column (sold separately) as shown in ﬁ gure 5.1. Tighten

swivel stop screw against extension column or reducer using 4 mm allen wrench (T).

NOTE: Swivel stop screw is used to jam against threads of extension column or reducer to prevent any excess

movement of projector mount assembly (A). Do not overtighten screw; overtightening screw will damage threads

making it difﬁ cult to separate products.

SWIVEL STOP SCREW

1 1/2" EXTENSION COLUMN

(SOLD SEPARATELY)

3/8 -16 HEX THIN

NYLON-INSERT

LOCKNUT

(NOT INCLUDED)

FRONT OF

MOUNT

FRONT OF

MOUNT

ﬁ g. 4.1 ﬁ g. 4.2

BACK OF MOUNT

3/8 -16 HEX THIN

NYLON-INSERT

LOCKNUT

(NOT INCLUDED)

ﬁ g. 5.1

3/8 -16 THREADED ROD

(NOT INCLUDED)

3/8 -16 HEX THIN NYLON-

INSERT LOCKNUT

(NOT INCLUDED)

3/8 -16 THREADED ROD

(NOT INCLUDED)

3/8 -16 HEX THIN NYLON-

INSERT LOCKNUT

(NOT INCLUDED)

Installation to Threaded Rod

(Professional installation only)

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Peerless PSMU-PRS Manuel Page 7